![]() Once I did this the unit wouldn't turn back on so I unplugged the unit from its 110v connection and reconnected the 110v cord into the wall, had to push the power button many times until the unit decided to turn on. I researched for a couple of hours reading lists of peoples complaints about how unsatisfied they all were with Harmon/JBL until I came across someone's post saying to hard reset the Extreme by holding down the pairing button & volume+ button at the same time. seems that the 2 pieces of technology didn't like each other I was about to give up and setup the return with Ebay seems it was a brand new JBL Extreme other than the one day I got to enjoy someone else's playlist. Once I was home I continued to have problems with the pairing of these 2 devices. Now what I ended up doing to get my fancy new Galaxy8 to work was a little more time consuming. we spent the remainder of the day enjoying music. We literally spent another 30 min trying to get the unit paired back up with my Samsung Galaxy 8 so we could enjoy some music, after the frustration started setting in we decided to pair it up with my friends IPhone 5 and off we went until about 10 min in the IPhone disconnected! We pulled over started looking at phone settings thinking it might be in the settings, decided that we would clear all Bluetooth paired history in the phone seems it had been paired with a few devices over the years! It worked. Small precision to avoid pressing too much on the parts so as not to deform them and make them unusable.I bought my Extreme in October of 2017, after fully charging the unit I paired it up with my phone and took off for a ride on the UTV, about 30 min into the ride we began to have this issue you're explaining. Take a clean, dry, lint-free cloth to clean the charging points of your wireless headphones JBL Endurance Race TWS, then on the charging points of the charging box of your earphones. If you see the charging case has no worries to charge, but only the wireless headphones JBL Endurance Race TWS refuse to charge, the contact points of the latter will certainly be covered with a film of grease or dirt. ![]() ![]() When the metal parts of your wireless headphones JBL Endurance Race TWS (the charging points) are dirty, your headphones will no longer be able to charge To ensure that the charging case of your wireless headphones JBL Endurance Race TWS is in the charging phase, check whether the LED located on its surface is in the process of flash by red, orange or green (the LED on the surface will flash of one color Red when the battery level is very low, Orange when the loading is halfway and then in shiso stable when the load of the case is at its maximum. ![]() Read More My JBL Tune 130NC TWS wireless headphones are no longer charging, what should I do?Īnd then make sure the charging box of your wireless headphones JBL Endurance Race TWS se recharge correctly : when the case is not charging, your wireless headphones JBL Endurance Race TWS will not be able to take charge in their turn since they recharge directly with the charging box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |